10L0L Speed Sensor for 48V Club Car DS & Precedent (2004+) — High-Speed Magnet, +4–6 mph Top Speed

10L0L's speed sensor with a high-speed magnet upgrades 48V Club Car DS and Precedent (2004‑up, ADC/IQ motor) carts to gain roughly 4–6 mph top speed while maintaining torque.

If your Club Car runs on a 48V ADC or IQ motor and feels limited at the top end, this direct-fit speed sensor plus upgraded magnet is a factory-style replacement engineered to read wheel speed differently, allowing the controller to deliver a higher top speed. It replaces OEM parts 11027049-01, 102704901, and 102265601 and comes with the magnet and mounting hardware for a straightforward swap. Note: this kit is not compatible with older GE motor systems.

How does this sensor increase top speed without changing the motor?

The sensor reads wheel/motor rotations via a permanent magnet. The included high-speed magnet presents a slightly different magnetic profile so the cart’s controller interprets a higher wheel speed and allows a higher top-end output while leaving torque characteristics intact. Gains vary by cart condition and setup.

• Works with 48V ADC (Advanced DC) and IQ system motors on Club Car DS/Precedent (2004+)
• High-speed magnet alters sensor signal for increased top speed
• Typical improvement: 4–6 mph depending on battery health and tires
• Does not change internal motor components or reduce torque

Will this part fit my Club Car and replace my OEM number?

Yes—this 10L0L assembly is designed as a factory-style replacement for the listed OEM references and matches the mounting and electrical connections used on 2004 and later Club Car DS and Precedent electric models equipped with ADC or IQ motors. Double-check your motor type before ordering.

• Direct replacements for OEM 11027049-01, 102704901, 1022656-01, 102265601
• Compatible with Club Car DS and Precedent 2004 and newer (48V models)
• Not compatible with earlier GE motor systems
• Factory-style fit for easy installation and secure mounting

How difficult is installation and what’s included in the package?

Installation is intentionally simple and can be completed in about 10–15 minutes with basic hand tools. You’ll remove the passenger-side rear wheel, unbolt the old sensor, swap in the new sensor and magnet, then remount the wheel. A how-to video is referenced in the product listing for visual guidance.

• Contents: 1 speed sensor, 1 high-speed magnet, mounting screws
• Tools needed: jack, lug wrench, screwdriver or 3/8" socket
• Estimated time: 10–15 minutes for a standard install
• Video walkthrough linked in the product ad for step-by-step help

What performance factors affect the actual speed gain?

The sensor and magnet can unlock higher top speed potential, but real-world results depend on several variables. Battery state-of-charge, controller programming, tire diameter, cart load, and drivetrain condition all influence how much speed increase you’ll notice.

• Battery age and charge level affect available power
• Controller settings or limits may cap top speed gains
• Larger or smaller tires change effective gear ratio and speed
• Worn drivetrain parts or heavy loads can reduce gains

Who is this for: This 10L0L speed sensor and high-speed magnet kit is aimed at Club Car owners who have a 48V DS or Precedent with an ADC or IQ motor (2004 and later) and want a simple, OEM-style replacement that can raise top speed without modifying the motor. It’s ideal for DIYers and fleet managers seeking a clean, bolt-on upgrade with included hardware and a short install time. If you have an older GE motor system, this kit is not compatible—confirm your motor type before purchasing.