Permabrace Boat Trailer Bunk Slide Kit, 20pcs. 16 pads 3 x 10 in + 4 end caps, ABS low-friction marine grade

Permabrace 20-piece bunk slide kit gives trailers a low-friction, corrosion-resistant surface for safe, smooth boat loading and unloading.

Replace worn or missing bunk material with a complete kit designed for double-deck trailers: 16 heavy-duty 3" x 10" ABS slide pads plus four bunk end caps. Built to withstand marine conditions, these parts simplify maintenance and restore reliable hull support and glide performance without specialty tools or complicated installation steps.

How will these bunk slides improve everyday launching and retrieval?

The ultra-low-friction ABS surface reduces resistance between your boat hull and the trailer bunk, letting boats slide on and off with less effort from a winch or manual push. That smoother motion lowers the chance of getting stuck at the ramp and speeds up routine launches and loading.

• 16 pads sized 3" x 10" spread across both trailer bunks for even contact.
• Low-friction finish that minimizes hull drag during retrieval.
• Four end caps protect extremities and prevent snagging on ramps.
• Compatible with common trailer widths: 2", 4", and 6" bunks.

Are these parts durable enough for saltwater and heavy use?

Yes — the slides and enders are molded from corrosion-resistant ABS plastic that resists rust, rot, and wear in both freshwater and saltwater settings. They’re engineered to support typical boat weights when mounted correctly, giving reliable performance season after season.

• ABS construction designed for marine exposure and UV resistance.
• Load support up to ~1,500 lbs for fiberglass hulls; higher capacities for metal hulls.
• Wear-resistant surfaces to extend replacement intervals.
• Not recommended for painted or delicate hull finishes to avoid scratching.

How difficult is installation, and what tools are required?

Installation is straightforward: pre-drilled, recessed screw holes let you align, drill pilot holes, and fasten the slides quickly. No special tools are needed beyond common drill bits and stainless fasteners, so you can complete the job in an afternoon.

• Pre-drilled recessed holes for flush-mounted screws and secure fit.
• Mounting works with standard drills, bits, and stainless screws.
• Quick swap for existing bunk material—no need to remove entire bunk board in many cases.
• Tip: unhook the boat before steep ramp descent to prevent unintended sliding.

Will these slides fit my trailer and boat type?

The kit is designed to fit most common bunk trailers and suits a wide range of small watercraft, from pontoons to fishing boats and personal watercraft. Check the trailer bunk width and your hull finish before ordering to ensure compatibility.

• Compatible with 2", 4", and 6" wide bunks on standard trailers.
• Ideal for pontoon boats, jon boats, jet skis, and many fiberglass or metal-hulled boats.
• Not recommended for boats with painted or delicate finishes to avoid abrasion.
• Comes as a full 20-piece set for double-deck trailers—no partial purchases needed.

Who is this for: The Permabrace 20-piece bunk slide kit is aimed at trailer owners, boat rental operators, marina maintenance crews, and DIY boaters who need a cost-effective, durable replacement for worn bunk material. If you want to restore smooth loading, protect hull contact points, and reduce ramp frustrations without professional help, this kit provides the parts and ease-of-installation needed for most small to medium trailers.