Bones Ceramic Reds Skateboard Bearings 8-Pack — Silicon Nitride Ceramic Balls, Pre-Lubricated with Speed Cream

Bones Ceramic Reds Skateboard Bearings 8 Pack are high-performance skateboard bearings built with silicon nitride ceramic balls, precision steel races, and Speed Cream lubrication for fast, durable rolls.

If you want bearings that combine lightweight ceramic balls with race-ready metallurgy and low-friction shields, these Bones Ceramic Reds deliver. Designed for street, park, and bowl skaters who demand consistent speed and easy maintenance, the set ships as eight bearings pre-lubricated and ready to install. The construction focuses on strength, minimal rolling resistance, and serviceability so you get long-lasting performance out of every wheel setup.

How do these bearings reduce friction and increase speed?

Friction reduction comes from the combination of ceramic balls and a smooth race finish, alongside a low-resistance shield design and Speed Cream lubrication. Ceramic balls spin lighter and resist heat better than standard steel, while the high-quality steel races are finished to tight tolerances for consistent contact.

• Silicon nitride (Si3N4) ceramic balls for lower mass and heat resistance.
• Polished, high-grade steel races for consistent rotation.
• Single non-contact rubber shield to limit drag while keeping contaminants out.
• Pre-applied Speed Cream racing lubricant for immediate low-friction performance.

What maintenance and cleaning approach keeps these bearings performing?

The removable single-rubber shield makes routine cleaning straightforward without damaging the bearing internals. Remove the shield carefully to clean or relube, then reinstall the shield or replace it if worn; frequent inspections extend life and maintain speed.

• Remove shield for deep cleaning with a solvent and dry fully before relubricating.
• Use a small amount of Speed Cream or compatible light bearing oil after cleaning.
• Reinstall the non-contact shield to balance protection and low friction.
• Inspect for chips or contamination—replace bearings if damage is visible.

What makes the materials and tolerances on these bearings better than basic bearings?

These bearings pair hot isostatically pressed (HIP) silicon nitride ceramic balls with superior-grade steel races and a precisely engineered nylon retainer. The combination yields improved roundness, dimensional stability, and reduced heat-related expansion compared with run-of-the-mill components.

• HIP silicon nitride balls for precise shape and durability under load.
• High-quality steel races with superior surface finish for smooth contact.
• Nylon ball retainer that holds balls securely while reducing weight and vibration.
• Manufactured to skate-rated clearances and tolerances for consistent performance.

How do these bearings fit into a complete skateboard setup?

They install like standard 8mm bearings into skateboard wheels and pair well with most axle sizes and spacers. Because they are pre-lubricated and supplied in an 8-pack, you can outfit a whole skateboard or keep extras for replacement without special preparation.

• Standard 608 size fits most skateboard wheels and trucks.
• Sold in an 8-pack—enough for four wheels on one skateboard.
• Pre-lubricated for out-of-box use; ready to ride immediately.
• Compatible with common spacers and axle nuts used in skate setups.

Who is this for: Bones Ceramic Reds are aimed at skaters who want a step up from entry-level bearings—street and park riders, competitive skaters, and anyone who values reduced friction, easier maintenance, and materials engineered for speed and longevity. If you regularly skate sessions that demand consistent roll and low drag, or you simply want reliable, pre-lubricated bearings that are easy to service, these are a strong choice.