DRIVE UP Club Car DS battery cables 48V 4-gauge set of 5 — direct-fit, corrosion-resistant

These DRIVE UP battery cables are a five-piece replacement set engineered to restore reliable 48V power connections on Club Car DS golf carts (1995 and later).

If your Club Car DS runs on six 8‑volt batteries and shows signs of poor connections, this kit offers a direct-fit solution. Each cable uses heavy 4‑gauge welding wire, fitted with 5/16" copper lugs and finished with a double-wall heat‑shrink sleeve to resist moisture and corrosion. The set replaces OEM part number 101795701 and is sized for straightforward installation without extensive modification.

What exactly is included and how long are the cables?

The kit contains five pre-measured battery jumper cables for the 48V series arrangement typical of Club Car DS models from 1995 onward. Each cable is 16.1 inches long to match factory routing between 8‑volt battery posts and to keep connections neat and secure.

• Set quantity: 5 cables (for the series battery string)
• Cable length: approximately 16.1 inches each
• Wire size: 4‑gauge welding cable for high current capacity
• Terminals: 5/16" copper lugs crimped on each end

How do these cables resist corrosion and wear?

Each lug connection is sealed with a double-wall heat‑shrink sleeve that forms a moisture barrier around the terminal and cable end. This protective layer reduces the chance of oxidation at the lug and prolongs service life in damp or humid golf‑cart compartments.

• Double-wall heat‑shrink provides a tight seal over crimps
• Copper lug contacts deliver strong conductivity and lower resistance
• 4‑gauge welding cable stands up to repeated flexing and vibration

Will these replace my OEM 101795701 parts and fit my cart?

Yes — the DRIVE UP set is designed as a direct replacement for OEM part number 101795701 used on Club Car DS models starting in 1995. The terminals, length, and wire gauge match factory specifications so they plug into existing battery posts without modification.

• Designed for 48V Club Car DS (1995-up) with six 8V batteries
• Meets the same terminal size and gauge used by the OEM
• Installable with basic hand tools and common crimping hardware

How difficult is installation and what tools are needed?

Installation is straightforward for anyone comfortable working with battery terminals. You’ll need basic tools: a wrench for terminal nuts, a ratchet or socket set for battery hold‑downs if removal is necessary, and a heat gun to shrink the protective sleeves if additional sealing is desired.

• Typical tools: wrenches, sockets, wire cutters, heat gun
• Recommended safety: disconnect batteries and wear eye protection
• Time estimate: about 20–45 minutes depending on access and experience

Who this is for: Owners and technicians of Club Car DS golf carts (1995 and newer) who need a reliable, OEM‑compatible repair for worn or corroded battery jumpers. This kit is suited for fleet maintenance shops, DIY enthusiasts wanting a direct swap, and anyone replacing multiple links in a 48V battery pack seeking durable, high‑current connections without rewiring the system.