WERLAHO EZGO 36V Powerwise Charger Control Board (28667G01) — Direct OEM Replacement with 50A Fuse and Mounting Kit

WERLAHO EZGO 36V Powerwise Charger Board (28667G01) is a direct replacement power control and input board designed to restore charging function for 1994‑up EZGO golf carts using 36‑volt Powerwise chargers.

This replacement board bundles the charger power control module, power input board, a 50A fuse, an insulated mounting pillar, and step‑by‑step wiring instructions. It is built to match OEM cross‑references including 28667G01, 28566G01, 28566‑G01, 28566‑G03, 28126‑G01 and related part numbers so technicians can swap damaged boards quickly and get carts back on the course.

How will this board fix a dead or inconsistent EZGO charger?

Replacing a faulty control or input board addresses common failure points such as blown fuses, bad relays, or damaged connectors that prevent charging. The included fuse and insulated pillar help you restore both protection and secure mounting when performing the repair.

• Directly replaces worn or burned charger control circuits
• Includes 50A fuse to restore overcurrent protection
• Matches multiple OEM part numbers for compatibility
• Comes with basic installation instructions and mounting hardware

What compatibility and electrical limits should I check before installing?

This board is intended for EZGO Powerwise 36‑volt chargers from 1994 and newer. Confirm the charger is the Powerwise style and verify the battery pack voltage; the relay on this board will not engage if battery voltage falls below about 28V.

• Designed for 36V Powerwise chargers (EZGO 1994‑up)
• Do not expect relay action when battery < 28V
• Verify wiring against the supplied diagram before power‑up
• Cross‑references include 28667G01, 28566G01 and similar

How difficult is installation and what tools are required?

Installation is a moderate DIY or professional task: basic hand tools, a multimeter, and the wiring diagram are usually sufficient. If you are comfortable removing the charger shroud, labeling wires, and replacing a small board and fuse, you can complete the swap in under an hour; otherwise a qualified technician should handle it.

• Required: screwdrivers, pliers, multimeter, basic socket set
• Includes insulated mounting pillar and instructions to guide alignment
• Disconnect batteries and follow safety procedures before working
• Contact seller support if wiring questions arise

What precautions and troubleshooting tips should I follow after replacing the board?

After installation, double‑check all electrical connections and ensure the 50A fuse is correctly seated. If the charger still does not engage, confirm the battery pack reads above 28V and use the wiring diagram to verify each connection; sometimes loose leads or corroded terminals are the real cause.

• Always isolate the battery pack before service
• Verify battery voltage > 28V to allow relay operation
• Inspect for corroded or swapped wires if charging does not start
• Reach out to the seller for clarifications on wiring diagrams

Who is this for? Technicians, fleet managers, and hands‑on EZGO owners who need an OEM‑crossing replacement for Powerwise 36V charger control failures will find this board useful. It suits repair shops handling mid‑90s and newer EZGO golf carts, DIYers comfortable with electrical troubleshooting, and anyone who prefers restoring original charger components over replacing the entire charger assembly.