FUCNEN 22" Screw-in Sand Anchor – One-Piece 304 Stainless Steel Auger, Collapsible T-Handle

FUCNEN's 22-inch one-piece screw-in sand anchor is a heavy-duty, non-welded stainless steel auger built to secure small boats, PWCs, kayaks, pontoon boats and shore setups in sand, mud, and shallow water.

This anchor combines a solid 304 stainless steel shaft and hardware with a one-piece auger base and a self-locking fastener system to deliver reliable holding power where soft bottoms threaten to leave smaller craft drifting. At 22 inches long and designed for easy, tool-free deployment with a collapsible T-handle, it’s targeted for shallow-water situations such as sandbars, coves, and beach anchoring. Corrosion-resistant construction and a maintenance-lite design mean long service life in both freshwater and saltwater environments.

How does this anchor hold better in sand and mud than a typical fluke or mushroom anchor?

The one-piece auger bites into soft bottoms and creates continuous lateral resistance rather than relying on plate contact. That means stronger grip under wind, current, or wave action without bending or breaking.

• One-piece screw-in auger for uninterrupted load distribution
• Designed for sand, mud, and clay where flukes often slip
• 22" length suitable for shallow bottom consolidation
• Secure performance for kayaks, jet skis, pontoons and small boats

How quickly can I set and remove the anchor on a day trip?

Deployment is fast: the T-handle collapses for storage and unfolds to twist the auger into the bottom within seconds. Removal is just as simple—unscrew and pull up, then rinse and stow.

• Collapsible T-handle for rapid, tool-free operation
• Self-locking nut holds hardware during use and transit
• Lightweight, single-piece design reduces setup steps
• Quick rinse-and-dry after use for minimal maintenance

Will this anchor resist corrosion and wear in saltwater conditions?

Yes. The shaft and all hardware are made from marine-grade 304 stainless steel to resist rust and pitting that commonly shortens anchor life in brackish or saltwater use. Proper rinsing and a light protective oil extend longevity further.

• 304 stainless steel shaft and components for corrosion resistance
• Non-welded, single-piece auger avoids weak welded seams
• Recommended post-use freshwater rinse and light lubricant
• Intended for long-term marine environments with routine care

What craft and conditions is this 22" anchor best suited for?

This anchor is optimized for shallow-water anchoring and small-to-medium watercraft where simplicity and portability matter. It performs well on sandbars, shorelines, calm coves, and tidal flats where a screw anchor’s continuous bite outperforms plate anchors.

• Ideal for jet skis, kayaks, small fishing boats, pontoons and PWCs
• Shallow water, sandbars, mudflats, and beach anchoring scenarios
• Not intended for heavy offshore conditions or large yachts
• Compact size and storage-friendly T-handle for day trips

Who is this for: The FUCNEN 22" Screw-in Sand Anchor is made for boaters, anglers, and recreational PWC or kayak owners who need a dependable, low-maintenance anchoring solution for shallow, soft-bottom environments. Choose this anchor if you value corrosion resistance, quick setup, and a one-piece auger design that minimizes failure points while maximizing hold on sandbars, coves, and shoreline stops.